Petite Coconut Popovers Recipe (2024)

FAQs

What is the secret to good popovers? ›

My biggest tip for creating perfect popovers is to use warm milk and room-temperature eggs with absolutely no chill on them. Do not take the milk and eggs from the fridge and use them. Cold ingredients will give you dense popovers. Warm ingredients will give you light, airy, and perfect popovers.

Preheating your oven to the correct temperature is probably the most important thing you can do to ensure popover success. The hotter your oven, the higher your popovers will rise. Which makes sense: the faster liquid in the batter turns into steam, the more chance your popover has to expand before its crust sets.

Popover pans are designed to convey heat directly to the batter, which is quite wet. As the batter bakes, that heat turns the moisture into steam, causing the popovers' dramatic rise. The deep cups of a popover pan give the batter plenty of room to rise, and provide support for the sides of the popovers as they do so.

If your popovers lose volume when they come out of the oven, they are probably underbaked. When these airy baked goods aren't cooked enough, too much steam stays trapped inside. That moisture condenses once they're removed from the oven, causing them to collapse.

The flour needs some time to absorb into the liquid, which not only thickens the batter a bit, it also allows the gluten molecules to relax which makes for a lighter, not chewy popover. The resting period also makes the batter more velvety and helps allow air bubbles to release.

Bread Flour or All-Purpose Flour: The key to making these popovers super light and fluffy is to use bread flour. Bread flour contains a higher amount of protein than all-purpose flour, causing it to yield a much lighter and fluffier popover.

Make the batter in a blender; make it with a whisk. Beat till smooth and frothy; leave some lumps. Everything should be at room temperature.

Remove from oven:

Popovers lose their crunch if they linger in the pan, so turn them out on a wire rack immediately and poke a small opening in the side of each with a paring knife to let the steam escape.

Bake for 15 to 20 minutes, then reduce heat to 350 degrees and continue baking for 15 minutes more, or until popovers are puffed and browned. Do not check popovers until they have baked for a total of 30 minutes. Remove from pan immediately and serve hot.

Should popover batter be lumpy? ›

Combine all ingredients in the order given and whisk just until combined. Don't overbeat the batter (a bit lumpy is ok). Allow batter to rest 10 minutes. Note that at this point the batter should be the consistency of heavy cream, but not alfredo.

Allow the batter to rest at room temperature while the oven preheats. Resting the batter really does result in better-risen popovers with an airier texture (as opposed to chewy). At least 15 minutes allows the starch molecules to expand and the gluten to relax.

A popover pan should be greased. I prefer to use melted butter, but oil or nonstick spray would work too. Greasing the pan ensures that the finished popovers don't stick and promotes browning on the exterior of the popover. After you've greased your pan, place it into the oven while it preheats.

Making Popovers Ahead: Popovers are the best when they're fresh from the oven. But if you need to make them ahead, just warm them in a 350°F oven until warm and crispy again, about 5 minutes. Freezing Popovers: Freeze baked popovers in an airtight bag or container for up to three months.

The container forms the steam released in the oven heat into one giant bubble. This steam is contained with gluten from flour proteins, starch, and protein from eggs. So the popover literally 'pops' with steam, but the steam doesn't escape because the stretchy protein holds it inside the batter.

Why are my popovers dense? Dense popovers (either from not rising or not getting nice hollows inside) can result from a couple things but usually it is by either not starting with room temperature eggs and milk, not preheating the popover pan, not using a quality popover tin, and/or making too thick of a batter.